Your cart
Chat
Contact us
Close contact box
Connect ID #
167 572 889 3
Connect ID #
167 572 889 3
All finished with your chat session?

We’ll email you a transcript of this conversation for your records.

Our contact center is currently closed.

Please enter your name.  
Please enter a valid email address. Why is this required?

For Tech Support, call 1-888-292-2575

Thank you, !
Our conversation will be emailed to
Chat Advisor Image

Your Advisor,

More about me
Please enter a question  
Don't wait on hold. We'll call you back when it's your turn to talk with the next available .
Please enter your name  
Please enter your phone number  

Please enter a message  

Calls may be recorded for training and quality control purposes.

We are located in Virginia USA.

NOCO GENPRO10X1

GEN series 1-Bank 10A Onboard 12V Battery Charger

Item # 598GPR10X1

This smart, durable charger works with a wide variety of 12-volt batteries.

This smart, durable charger works with a wide variety of 12-volt batteries.

Item # 598GPR10X1

In stock
$124.95

Hands-on research

We double check the details on each item.

Since 1974

Years of experience making people happy.

Car-specific installation packages

Deep discounts on the essential accessories that help your new gear work with your car.

About the NOCO GENPRO10X1

One tough charger

Many marine, ATV, and industrial 12-volt applications need extra protection against dirt and water. The rugged NOCO GENPRO10X1 charger has earned an IP68 rating, which means it's totally waterproof and saltwater-tested for corrosion resistance. Its shock- and vibration-resistant construction has the durability you need in demanding applications.

One tough charger

Many marine, ATV, and industrial 12-volt applications need extra protection against dirt and water. The rugged NOCO GENPRO10X1 charger has earned an IP68 rating, which means it's totally waterproof and saltwater-tested for corrosion resistance. Its shock- and vibration-resistant construction has the durability you need in demanding applications.

Smart charging

The GENPRO10X1 has brains too. It charges regular and deep-cycle batteries up to 230Ah, while monitoring charge level so you get a complete charge with no risk of overcharging. Built-in circuit protection gives you peace of mind from reverse polarity, sparks, overheating, and short circuits. Selectable charging modes let you match the charger to the battery type and voltage, provide a charge to old or idle batteries, or go into standby mode so no unnecessary AC power is used.

Noco GENPRO10X1 12V battery charger

You can safely mount this charger close to your battery for easy access to the selectable charging modes.

Easy placement

This charger's small size gives you plenty of options for installation. It mounts directly onto a boat or trailer so you can place the charger as close as you like to the battery. The six-foot AC and DC cords give you slack if you need to place the charger farther away. This little problem-solver will bring the juice you need right to the place you need it.

READ LESS

Product highlights:

  • 1-bank 10A onboard battery charger
  • charges batteries up to 230Ah
  • selectable charging modes depending on battery type and voltage needs
  • compatible with all types of 12V lead-acid and Lithium-ion batteries - including Wet Cell (Flooded), Gel Cell, AGM, Calcium, and Maintenance-Free Batteries
  • IP68 rated (dust- and water-proof)
  • detects battery sulfation and acid stratification to restore lost battery performance
  • maintains charge at normal level indefinitely without over-charging
  • built-in protection circuity
  • dimensions (Crutchfield in-house measurements including attached cable housings): 6.37"L x 5.76"W x 2.83"D
  • warranty: 3 years
  • Our 60-day money-back guarantee
  • MFR # GENPRO10X1

What's in the box:

  • Onboard battery charger w/attached 6' AC power cord and 6' power/ground cables (inline 15A ATO fuses on both cables)
  • Two 1" self-tapping screws
  • User guide & Warranty
  • Accessory brochure

Customer reviews

Loading reviews...

NOCO GENPRO10X1 reviews

Average review:

1 review

Thanks for submitting your review

Filter by rating

Customer photos

Sort reviews

Sort by:
Items per page:
View page:

Verified customer (What's this?)
Verified employee purchase (What's this?)

Pros:

Cons:

Crutchfield response

<< >>

More details on the NOCO GENPRO10X1

Mark G.
The NOCO GENPRO10X1 replaces these items:

Product Research

Features

Onboard Battery Charger (1 Bank/10 Amp): The Noco Genius GENPRO10X1 is an Onboard Battery Charger, rated at 10-amps for charging and maintaining a single 12-volt Marine, Starter, or Deep-Cycle battery. Its waterproof, shock, and vibration-resistant design allows it to be used in a variety of 12V applications including boats, gas vehicles, electric vehicles, and industrial equipment. It monitors battery activity for safe, fast and efficient charging of Wet, Gel, AGM, and Maintenance Free batteries without the worry of overcharging. And its one of the most advanced charging systems, designed for improved battery performance and longevity.

Compatible Battery Types: The GENPRO10X1 Onboard Battery Charger is suitable for charging all types of 12V lead-acid and Lithium-ion batteries - including Wet Cell (Flooded), Gel Cell, AGM, Calcium, and Maintenance-Free Batteries with a capacity of up to 230Ah.

Protection Circuitry: The GENPRO10X1 is a non-igniting and temperature controlled onboard battery charger for safe and worry-free operation. Its built-in redundant levels of safety protection  protect against adverse and abnormal conditions - like reverse polarity, sparks, overcharging, over-current, open circuits, short circuits and overheating. Four Error LEDs on the charger will light to indicate one or more of the aforementioned problems is present.

Ultra-Rugged Construction: The GENPRO10X1 is a 100% completely sealed waterproof onboard battery charger and is fully submersible. Its designed to operate in extreme conditions with a waterproof, shock, and vibration resistant rugged construction, as well as, saltwater tested to combat corrosion.

Intelligent Maintenance Technology: Most manual, automatic or semi-automatic battery chargers continuously trickle charge batteries, making them susceptible to overcharge, which limits battery life. Noco's intelligent battery maintenance technology monitors battery activity and only begins charging when needed, and allows for continuous operation without user intervention and zero risks of overcharging your battery. An integrated thermal sensor detects the ambient temperature and alters the charge to eliminate over-charging in hot climates and under-charging in cold climates. The charger can be left connected to the battery indefinitely.

12V Repair: 12V Repair is an advanced battery recovery mode for repairing and storing old, idle, damaged, stratified or sulfated batteries. Batteries tend to become damaged if kept at a low charge and/or never receive a full charge. Battery sulfation and stratification will artificially raise the open circuit voltage of the battery, causing it to appear fully charged while providing low capacity. 12V Repair tries to reverse these problems and is best performed after taking the battery through a full charge cycle.

Note: 12V Repair mode is for 12-volt lead-acid batteries only and should be used with caution. This mode uses a high charging voltage which can affect sensitive vehicle electronics. It may also cause some water loss in wet-cell (flooded) batteries. Disconnecting the battery from the vehicle before using 12V Repair mode is highly recommended.

Force Mode: This mode allows the charger to be manually set, or "forced", into charging when the connected battery's voltage is too low to be detected. After 5 minutes in Force Mode, the charger will return to the normal charge operation.

Charging Modes: With the Noco Genius GENPRO10X1, you can simply push of a button to switch between various charging modes within one, complete multi-purpose battery charger.

  • 12V (14.5V/10A): For charging 12-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free and Calcium batteries (up to 230Ah). When selected, the white 12V LED will illuminate.
  • 12V AGM (14.8V/10A): For charging 12-volt advanced AGM batteries (up to 230Ah), which requires a higher than normal charging voltage. When selected, the white 12V AGM LED will illuminate.
  • 12V Lithium (14.6V/10A): For charging 12-volt Lithium-ion batteries (up to 230Ah), including Lithium iron phosphate. When selected, the blue 12V Lithium LED will illuminate. For use on batteries with Battery Management Systems (BMS) only.
  • Force Mode (10A): For charging batteries (up to 230Ah) with a voltage lower than 1V. This charge mode will operate for 5 mins, then return to standard charging mode. When selected, all charge mode LEDs will flash while in Force Mode.
  • 12V Repair (16.5V/1.5A): An advanced battery recovery mode for repairing and storing, old, idle, damaged, stratified or sulfated batteries. When selected, a red 12V Repair LED will illuminate.
  • Standby (No Power): In standby mode, the charger is not charging or providing any power to the battery. Energy Save is activated during this mode, drawing microscopic power from the electrical outlet. When selected, the orange Standby LED will illuminate.

Charge LEDs: The charger has four Charge LEDs (25, 50, 75, &100%). This Charge LED indicates the connected battery's state-of-charge (SOC).

  • The 25% Charge LED will slowly pulse when the battery is less than 25% fully charged. When the battery is 25% charged, the red Charge LED will be solid.
  • The 50% Charge LED will slowly pulse when the battery is less than 50% fully charged. When the battery is 50% charged, the red Charge LED will be solid
  • The 75% Charge LED will slowly pulse when the battery is less than 75% fully charged. When the battery is 75% charged, the orange Charge LED will be solid.
  • The 100% Charge LED will slowly pulse when the battery is less than 100% fully charged. When the battery is fully charged, the green LED will be solid, and the 25%, 50% and 75% Charge LEDs will turn off.
  • During maintenance charging, the 100% Charge LED will pulse slowly. When the battery is topped off and fully charged again, the 100% Charge LED will turn solid green.

Charging Times: The time required for the GENPRO10X1 to charge a normally discharged battery is shown below. Deeply discharged batteries may take longer to charge depending on the depth of discharge (DOD). The charge time is based on an average depth of discharge to a fully charged battery.

12V Battery Size (Ah) Approximate Time to Charge (Hours)
20 1.5
40 3.0
80 6.0
100 7.0
230 17.3

Note: The above table is for reference purposes only. Actual data may differ due to battery conditions. The time required to charge a normally discharged battery is based on an average DOD of 50%.

Advanced Diagnostics: Noco chargers include built in redundant levels of safety protection for their chargers to keep you and your vehicle safe. It offers protection against reverse polarity, sparks, overcharging, over current, open-circuits, short-circuits, and overheating. Four illuminated icons can display 5 errors, Standby, Battery Voltage, Short Circuit, Reverse Polarity, and Temperature (too high/low), by lighting or flashing when a corresponding problem is detected, letting you know immediately what the problem is and how to remedy it.

Mounting & Installation: The GENPRO10X1 has two external holes for mounting (screws included). It is important to keep in mind the distance to the battery. The Noco charger is outfitted with an attached 6' AC power cord and a 6' DC cable. The AC power cord is terminated by a two-prong AC plug, while the 6' DC cable is terminated by power & ground eyelets (3/8").

Rugged Construction w/ 3 Year Warranty: The Noco Genius GENPRO10X1 charger is designed for a rugged working environment and is backed with a 3 Year Warranty.

Specifications:

  • Input/Working Voltage (AC): 120-240VAC, 50/60Hz
  • Output Power: 150W (Max)
  • Charging Voltage: Various
  • Charging Current: 10A (@ 12V)
  • Low-Voltage Detection: 1V (12V)
  • Battery Type: 12V
  • Battery Chemistries: Wet, Gel, MF, CA, EFB, AGM, Calcium, Lithium
  • Charging Banks: 1
  • Battery Capacity: Up to 230Ah (all battery sizes)
  • Back Current Drain: <0.5mA
  • Operating Temperature: -4˚F to 122˚F
  • Weather Protection: IP68
  • Dimensions: W = 5.76", H = 2.83", Depth = 6.37" (including cables)
  • Weight: 4 lbs.

Loading accessories...

Loading articles...

TOP
Compare the sound