About the Wiring Kit for Processors and Low-Current Devices
Power on
Power on
If you need a source of 12 volts to power a low-current, low-power device like a radar detector, a dash or rear-view camera, an amplifier turn-on circuit, or an active signal processor like a DSP, LOC, EQ, or line driver, this power wiring kit will work perfectly in just about any situation. The kit includes enough wire to allow you to connect directly to the car battery or to your amp system's distribution block. The package actually contains enough pieces to accommodate a couple of low-power installations.
Installation note: The 18-gauge wire in this package can only safely handle current draw of up to 5A for a short wire run. Using a higher-rated fuse or device with this wiring kit could result in melted wires or a fire.
Product highlights:
- wiring kit for low-power accessories
- package includes:
- Install Bay IBR98 25' two-conductor 18 AWG wire (red & black)
- Posi-Products Fuse Holder Kit: 2 blade fuse holders
- Install Bay IBR111 ATC fuses: two 1-amp, two 3-amp, two 5-amp fuses
- warranty: 60 days
- Our 60-day money-back guarantee
What's in the box:
- 25' Two-conductor 18-gauge wire (red & black)
- 2 Black 12- to 18-gauge Posi-Fuse Blade Fuse Holders
- Two 1-amp ATC fuses
- Two 3-amp ATC fuses
- Two 5-amp ATC fuses
Reviews
Customer reviews
Loading reviews...
Wiring Kit for Processors and Low-Current Devices reviews
Average review:
Thanks for submitting your review
Customer photos
More details on the Wiring Kit for Processors and Low-Current Devices

Product Research
Features
Overview: This kit includes a 25' section of 2-conductor 18-gauge wire, two fuse holders, and six ATC automotive blade-style fuses (two 1-amp, two 3-amp, and two 5-amp). The fuse holders will accept 12- to 18-gauge wire, and each holds one ATC, ATO, or MINI blade-type fuse. To attach the wire to the fuse holders strip the stranded wires, insert them in the end caps, and hand tighten. The wire ends are locked between opposing cone shapes to create a dirt-, vibration-, and heat-proof housing. The connectors are also reusable.
Fuse Holder Dimensions:
- Length: 2.32"
- Width: 0.38"
- Height: 0.83" (0.71" with mini fuse)
- Diameter of Hole in Caps: 0.15"
Fuse Dimensions:
- Width: 0.73"
- Height: 0.732"
- Depth: 0.19"
Loading accessories...
Customer Q&A
Loading articles...