About the Wet Sounds REV10-RGB
See a little light with Wet Sounds
Add a little light to your weekend on the water with these LED light rings from Wet Sounds. Designed to work with 10" Wet Sounds Revolution Series speakers, these festive multi-colored light strips (also available in blue) are sized to fit perfectly in the durable injection-molded rings.
Additional parts are required for installation. See "Details" tab for more information.
Wet Sounds REV10-RGB reviews
Thanks for submitting your review
More details on the Wet Sounds REV10-RGB
Compatibility: The LED light rings are compatible with the REV 10 marine tower speakers from Wet Sounds (sold separately). Your REV 10 marine tower speaker will need to have a TC-3 compatible swivel-mount bracket installed. If your speaker has a fixed bracket installed, you will need to replace it with Wet Sounds swivel mini-bracket. You will also need the Wet Sounds TC3-S 6-pin connector harness (sold separately), which replaces the included fixed bracket and 2-pin speaker connector harness.
Installation Notes: The marine tower speaker's grille and driver will need to be removed to install the LED light ring. You will also need to remove a rubber plug along the front baffle which allows the LED ring's wiring feed through the tower speaker.
Wiring: Each LED ring features a Red, Green, Blue, and Black wire lead which connect to the wiring inside the REV 10 speaker. There is a molex-plug which needs to be cut-off in order to hardwire the LED ring inside the speaker. The Wet Sounds TC3-S 6-pin connector harness (sold separately) then provides Red, Green, Blue, and Black wire leads outside the speaker to connect to power and ground, or to connect to the Wet Sounds RF-RGB-MC V2 RF Controller (sold separately).
Note: If not using the Wet Sounds RF-RGB-MC V2 RF Controller (sold separately), you will be limited to either Red, Green, or Blue LED illumination (you will not be able to switch between colors).