About the Wet Sounds SW-10FA-S2-W
Get some bass for your boat
Get some bass for your boat
Wet Sounds designed their SW-10FA-S2-W marine subwoofer to give you impressive bass, worry-free performance, and stylish looks. Designed by boaters for boaters, this sub's classic white finish and subtle grille blend right into most boat interiors.
Made for marine use
This 10" sub is built to survive the often-harsh extremes of the marine environment — the cast-aluminum frame is powder-coated, the speaker terminals are gold-plated, and the cone is made from injection-molded composite. The sub's spider and surround are both made from durable rubber, so they'll resist moisture and damaging sunlight for seasons to come.
Install it almost anywhere
This sub works perfectly in a 1.3 cubic foot sealed enclosure, but Wet Sounds designed it for "free-air" applications, which is a very groovy way of saying you don't need to put this sub in a box to get the low-end thump you want. Mount it in a bulkhead, storage compartment, or wherever it fits — you'll be impressed by the sound regardless.
- 10" 2-ohm marine subwoofer
- injection-molded composite woofer with rubber surround
- powder-coated cast aluminum frame
- gold-plated, marine-grade brass binding posts
- marine-grade rubber spider and magnet boot
- designed for free-air applications or a 1.3 cu. ft. sealed enclosure
- power range: 50-300 watts RMS (600 watts peak)
- frequency response: 20-500 Hz
- sensitivity: 88 dB
- top-mount depth: 4-9/16"
- cutout diameter: 9-3/8"
- warranty: 2 years
- Our 60-day money-back guarantee
- MFR # SW-10FA-S2-W
What's in the box:
- 10" Marine subwoofer
- White grille
- Six 1-1/2" Stainless steel Phillips head screws
- Owner's manual
Thanks for submitting your review
More details on the Wet Sounds SW-10FA-S2-W
Rubber Spider: Durability is improved by the rubber spider Wet Sounds developed for their marine speakers.
Terminals: The wire terminals are gold plated binding posts; they will accept pin connectors, spade lugs, single banana plugs, and bare wire up to 10 gauge. The binding posts are spaced too far apart (approximately 1-1/8") to accept standard dual banana plugs.
Free Air Mounting: The SW-10FA-S2 is optimized for Free Air (infinite-baffle) mounting.
Sealed Enclosure: If mounting the subwoofer in an enclosure, use a 1.3 ft³ sealed enclosure. Wet Sounds recommends building the enclosure of marine grade plywood with a minimum thickness of 3/4". Internal bracing should be incorporated so the enclosure is as rigid as possible. All joints should be glued and fastened with screws. Additionally, internal joints should be covered with a small bead of silicone adhesive to ensure the enclosure is completely air-tight. To avoid air leakage, a foam rubber gasket or similar sealing method should be applied between the loudspeaker and the enclosure.