- 2-1/2 way, 3-driver design
- handmade JET 5 folded ribbon tweeter for lightning-fast response and wide dynamic range
- dual 7" aluminum/paper sandwich cone drivers
- one for bass frequencies, and one for midbass/midrange
- frequency response: 30-50,000 Hz
- sensitivity: 88 dB
- impedance: 4-8 ohms compatible
- recommended amplifier power: up to 130 watts RMS
- wood veneer exterior with high-gloss lacquer finish
- bass-reflex cabinet with down-firing port at the speaker's sturdy aluminum bass plate
- angled cabinet for improved high-frequency performance and musical imaging
- dual sets of binding post speaker terminals allow bi-amping or bi-wiring
- made in Germany
- no grille is included
- 9-1/16"W x 39-3/8"H x 10-1/2"D
- weight: 42.1 lbs.
- warranty: 3 years
- Our 60-day money-back guarantee
- MFR # VFS407-GN
What's in the box:
- Floorstanding loudspeaker
- Base plate
- 2 Jumper straps (pre-installed)
- 4 Spikes
- 4 Pucks
- 4 Rubber pads
- 4 Machine screws
- 4 Washers
- Operating And Safety Instructions
Thanks for submitting your review
More details on the ELAC VELA FS 407
Features & specs
|Tweeter Size (inches)||---|
|Midrange Size (inches)||N/A|
|Woofer Size (inches)||6|
|Built-in Powered Sub||No|
|Dolby Atmos Drivers||No|
|Parts Warranty||3 Years|
|Labor Warranty||3 Years|
|Frequency Response||30-50k Hz|
|Subwoofer Amp Power||---|
JET 5 Tweeter with Wave Guide: The Elac Vela FS 407 floorstanding loudspeaker features a JET 5 folded-ribbon tweeter with an integrated waveguide for exceptional high frequency reproduction for those who want to hear the most out of their high-resolution movie and music soundtracks. The JET 5 folded-ribbon tweeter is known for its lightning-fast response, wide dynamic range, minimal distortion, lots of headroom, and its wide frequency range. The JET 5 tweeter creates an effortless, airy and resonance-free high-frequency image up to 50,000 Hz; and with its linear frequency response is ideally suited for the reproduction of hi-res formats.
Dual Aluminum-Sandwich (AS) Woofers with Crystal Membrane: The Elac Vela Series floorstanding loudspeaker (VFS 407) houses two 6" Aluminum-Sandwich (AS) cone woofers with Crystal Membrane technology and rubber surround. A crystal-shaped inverse aluminum dome is joined to the paper cone in a special gluing process to result in the desired sandwich construction. Resembling the surface of a large crystal, the aluminum-foil stamping stiffens the aluminum dome, diminishing resonances and minimizing coloration, while improving power handling and dynamics. The combination of aluminum and paper creates a woofer cone that is stiff, precise, linear, and lightweight. The result is mid and bass frequencies that are clean, clear, and powerful.
Bass Reflex Angle Cabinet: The Elac Vela FS 407 features a bass reflex cabinet with a rear and down firing port for greater efficiency and bigger bass response. The down-firing bass reflex port is integrated into the speaker cabinet's sturdy aluminum bottom plate. The speaker cabinet has a trapezoid shape and is angled rearward with a convex shaped baffle. The angling of the cabinet and unique design of the baffle improves the speaker's acoustics and soundstage.
Note: These Vela Series does not come with grilles.
Dual Binding Posts: The Elac Vela Series floorstanding loudspeaker (VFS 407) is outfitted with two sets of heavy-duty binding posts allowing to bi-amp or bi-wire the floorstanding loudspeaker. These binding posts ensure a secure connection to many types of cable and connectors. The binding post terminals will accept banana plugs (single only), pin-connectors, spade-lugs and bare wire (up to 10AWG).
- Bi-Wiring: Bi-wiring can provide noticeable improvements in the overall transparency of your loudspeakers. Run separate speaker wires to the low & high frequency drivers from a single amplifier (the upper set of binding posts are for the high frequency drivers; the lower set of binding posts are for the low frequency drivers).
- Bi-Amping: Bi-amping allows you to use separate amplifiers for the high & low frequency sections of your loudspeaker for greater dynamic range & lower distortion. We recommend that your separate amplifiers have identical gain to preserve the speaker's voicing balance.
Note: If you decide to bi-wire or bi-amp, you must remove the jumpers between the terminal posts (failure to do this could result in damage to your amplifier and loudspeakers).
Rubber or Spike Feet: The Elac Vela FS 407 comes with a heavy aluminum plinth (base) that screws into the bottom of the speaker cabinet. The included spike feet screw into the bottom of the aluminum plinth and are designed for carpeted flooring. The supplied isolation pucks can be placed under the spike feet to protect hardwood, tile, vinyl, and laminate flooring. Self-adhesive rubber pads stick to the bottom of the isolation pucks to further protect your floors.
- Dimensions with Spike Feet: 8.8125" (w) x 40.25" (h) x 10.75" (d)
- Dimensions with Spike Feet & Isolation Pucks: 8.8125" (w) x 40.4375" (h) x 10.75" (d)
Note: The floorstanding loudspeaker should always be used with the plinth (base), spike feet, and isolation pucks installed for optimum sound quality and maximum stability.
Applications: The Elac Vela Series floorstanding loudspeaker (VFS 407) can be used in a 2ch stereo application, or used as your front speakers and/or rear surround speakers in a multichannel home theater application.
- 2Ch Stereo or Front Speaker Placement: For optimum stereo imaging, place the speakers so that an equilateral triangle is created between the speakers your main listening position. You can also angle ("toe-in") the speakers towards the listening position to gain a more focused central image.
- Rear Surround Placement: In a 5.1-channel surround setup, avoid placing the speakers forward of your listening position. The speakers should be spread apart wider than the front speakers.
Note: In either application, the speaker should be placed 1' to 2' away from boundaries such as wall and corners. Close proximity to a side or rear wall will enhance bass performance, but being too close may result in bass that is unnatural.
Vela Series: The Vela Series from Elac is built to the highest standards in Germany using high-quality components that are carefully constructed to deliver the best-in-class sound quality. The Vela Series consists of two floorstanding loudspeakers (VFS 407 / VFS 409), a bookshelf loudspeaker (VBS 403), and a center-channel speaker (VCC 401). The Velas Series delivers high quality sound with a sophisticated look for today's modern lifestyle.
Optional Powered Subwoofer: Add an Elac powered subwoofer (sold separately) to the Vela series to bring more bass to your movie and music soundtracks.