Secura QLF314

Features

TV Compatibility: The Secura QLF314-B2 is a full-motion wall-mount bracket for 40"-70" flat-panel TVs up to 80 lbs. The TV must also meet the following VESA and screw size requirements.

• VESA Sizes: 100mm x 100mm to 600mm x 400mm
• Screw Size: M6 or M8

Note: Additional hardware may be required for your specific model of TV. For example; shorter or longer screws, thicker or slimmer washers or spacers. These additional accessories can often be found at your local hardware store.

Steel Construction: The Secura QLF314-B2 wall-mount bracket is constructed of heavy-gauge steel with a durable powder-coated black finish. This solid construction provides strength and increased safety.

Full-Motion Design: Thanks to its full-motion design, the Secura QLF-314-B2 wall-mount bracket lets you enjoy a great picture on your TV no matter where you watch it. You'll be able to tilt, swivel, extend, and level your wall-mounted TV without the need for tools.

• Extend: The QLF-314-B2 lets you extend your TV 3.5" to 14.0625 " from the wall to give you greater flexibility with your TV's viewing angle and to provide easier access to the TV's rear-panel connections
• Tilt: If your TV has to mounted low below a structure or high above a mantle or fireplace, you can tilt it 5° up or 15° down for the perfect viewing angle. The maximum tilt range will depend on size of TV.
• Swivel: You are able to swivel your mounted TV to left 45° or to the right 45°, so you can have the perfect view of the screen no matter where you sit in the room. The maximum swivel range will depend on size of TV.
• Roll: You can also raise and lower the the sides of the TV from -5° to +5° to make sure the TV is level once it is mounted on the wall.

Single-Stud Installation: The wall bracekt can be mounted to a single wood stud, or anchored to a solid concrete or concrete block wall using the supplied lag bolts (and wall-anchors).

• Drywall & Wood Stud Notes: Wood studs should measure at least 2" x 4" (nominal) or 1.5" x 3.5" (actual). Drywall covering thickness should not exceed 5/8".
• Concrete Block Wall Notes: Minimum concrete block size of 8" x 8" x 16" is required. Minimum solid concrete thickness of 8" is a requirement.

Installation Tools: The following tools are recommended for mounting the QLF314-B2.

• Tape measure
• Pencil
• Stud finder
• Level
• Awl
• Drill
• 7/32" Drill bit (for wood stud)
• 3/8" Masonry bit (for concrete block)
• 1/2" Socket wrench
• Phillips-head Screwdriver
• Hammer