Skip Navigation

Tips on installing a navigation system

Get better GPS performance with these suggestions

The Crutchfield writing team is a group of full-time, in-house copywriters who share a passion for consumer electronics. In addition to creating the articles and videos you find in the Research area of the Crutchfield website, these hard-working and talented people write the informational copy for the products on our website and in the Crutchfield catalog. Our writers constantly research the latest products, technologies, and industry trends, so that we can bring you the most helpful information possible.

More from Crutchfield Writing Team

There are two basic types of in-car GPS navigation systems: in-dash and portable. This article will give you some tips on installation considerations for both systems, but focuses on the in-dash systems, since they are more involved. After reading this article, see our Navigation Installation Guide for detailed installation instructions.

Navigation receiver in dash

In-dash Navigation Systems

In-dash navigation systems consist of 2 or 3 parts: a car stereo with a built-in screen, an external GPS antenna, and occasionally, a hideaway connection box that contains audio/video inputs and outputs. These navigation systems require some extra wiring connections versus regular in-dash stereos.

Parking brake

For safety reasons, any video screen in the front of the car must be attached to the parking brake wire. This applies to GPS systems too. Some of the more advanced navigation functions are disabled while the vehicle is in motion. If you want to look up a phone number or change the default settings of the unit, you'll need to pull over first. In rare cases, a connection to the foot brake may be required also.

Vehicle Speed Sensor (VSS)

In addition to the standard power and ground leads, some navigation systems also connect to a vehicle's Vehicle Speed Sensor (VSS) wire. Your vehicle's cruise control uses the VSS wire to determine the vehicle's speed — it serves the same function for the navigation system. (Don't substitute the tachometer signal wire for the VSS wire — the tach signal wire sends pulses as long as the engine is running, even when the car is sitting still.) The VSS wire sends a series of pulses (from 800 to just over 1,000 per mile) only when the vehicle is in motion. If the VSS wire is not hooked up, the navigation system may not realize that the car is moving at all, and might be unable to track position as accurately.

Reverse signal

Many systems also connect to the vehicle's reverse (or back-up light) signal wire — this connection tells the navigation system when the vehicle is traveling in reverse. If this wire is not hooked up, then the vehicle direction will not track properly, and the navigation system won't be able to do its job.

We can help

Our highly trained Technical Support staff can provide parking brake, VSS, and reverse wire information for most vehicles. They're available seven days a week (have your invoice handy when you contact us). Even if the information is not available for your vehicle, they can still help you figure out which wires are the ones you need.

GPS Antenna

The navigation computer determines its position by communicating with the Global Positioning System satellites through its GPS antenna. The waterproof antenna may be mounted inside or outside of the vehicle, but best results are usually obtained by mounting it outside on the roof.

If you opt for interior mounting, keep in mind that the GPS antenna cannot "see" through metal. Reception is also prone to electromagnetic interference when mounted in the interior of the vehicle. Do not place the antenna on the dashboard or rear deck if:

  • you have a wired rear defroster
  • you have metallic window tint
  • you have a solar reflective window
  • you have a windshield mounted radio antenna

The GPS antenna should be placed at least 5 inches from any physical obstruction like the "A" pillar or a 2-way communication antenna. The antenna attaches to sheet metal using a magnet or adhesive, and the cable is routed to the interior through a rear window (or door) seal.


Once installed, your navigation system must be calibrated according to the manufacturer's instructions. Some systems will also require recalibration after a tire change.

Installing a navigation unit is like putting in an in-dash receiver or an amplifier — with a few added twists. You should have no problem setting up a navigation system if you've installed this type of equipment before.

Remote-mount navigation systems

A remote-mount system consists of a separate navigation computer (with an external antenna) that must be connected to a compatible car stereo. Drivers interface with them the same way they would an in-dash system. These are not as common today, but they're just as effective as most in-dash systems, provided their mapping data is up to date and they're properly connected.

Alpine INE-W960 navigation receiver

In-dash navigation systems, like the Apine INEW-960, provide you with large displays and easy touchscreen controls.


Portable GPS navigators

Part of the appeal of portable GPS navigators is their ease of installation. Most portables use a suction-cup mount to attach directly to the windshield or your dash (make sure that windshield-mounted electronic devices are not prohibited or regulated in your state or locality). Power for the GPS unit is provided by a 12-volt power adapter.

Simply clean a small area of the windshield (not in your direct view of the road) with glass cleaner or rubbing alcohol, and attach the suction cup to clamp it securely to the glass. Your portable GPS unit may also come with another type of installation apparatus, such as a bean bag mount that uses a weighted non-skid rubberized pad to stay put on an uneven surface, or adhesive brackets to mount the unit directly to the dash. The same precautions for the GPS antenna listed above apply for portable units with built-in antennas — you want to make sure the unit's built-in antenna's reception remains unimpeded.

Portable GPS navigator with windshield mount

The windshield mount should securely hold your portable GPS navigator in place.

  • Gary from Florida

    Posted on 6/29/2015

    I installed a double din audio system with gps,everything works,but the navigation system.I have reset it and it still shows it not reading software,it has a 4g card in it with maps on. It,but still no gps.i have tried by pulling card and put back,same problem..can you help?

  • Alexander Hrabe from Crutchfield

    Posted on 6/30/2015

    Gary, if you bought your gear from Crutchfield, you can call Tech Support for free help troubleshooting your system. If you purchased your equipment elsewhere, you can still get expert Crutchfield Tech Support - 90 days-worth for only $30. Check out our tech support page for details. Alternatively, you may want to try the manufacturer's Tech Support if the radio is under warranty.

  • Robert Young from Austintown, Ohio

    Posted on 7/22/2015

    I have a 2008 Mitsubishi Eclipse GS. Installed an aftermarket stereo...the speedometer and gear indication light went out. I there is something not hooked up right. The computer said it Vehicle Speed Sensor.

  • Alexander Hrabe from Crutchfield

    Posted on 7/23/2015

    Robert, it's hard to say for sure. Short of heading to the dealership for repair, you could give our Tech Support a call, which is a free service if your purchased the receiver from us. Or you could open up your dash, retrace your steps to an extent and double-check all of your connections. You may find wiring information in our online Knowledge Base.

  • Sunil from surat

    Posted on 8/1/2015

    How to activate Navigation system in dashboard player.

  • Alexander Hrabe from Crutchfield

    Posted on 8/3/2015

    Sunil, Without more information, it's hard to answer your question. If a navigation receiver is installed correctly, all you need to do is select the navigation interface and enter a location. You'll receive directional prompts until you reach your destination. If that function is not working in your navigation receiver, it may not have been installed correctly or a subscription to a service may be required.

  • Brent from United States

    Posted on 8/5/2015

    I have a pyle pldnb78i in dash gps radio. Everyday certain hours the screen is jist black, but everything else still works. Seems to be from midnight to 10am daily. There is nothing in the settings that I can find that will cause this. Can anyone help?

  • Alexander Hrabe from Crutchfield

    Posted on 8/6/2015

    Brent, we don't carry that stereo, but you're best bet may be to contact Pyle customer support. Good luck!

  • tiffany from Baltimore md

    Posted on 8/16/2015


  • Steve from San Carlos

    Posted on 8/30/2015

    I have a 2007 ram .which wire is the speed signal,and where is it,color and location.

  • Alexander Hrabe from Crutchfield

    Posted on 8/31/2015

    Steve, you can try searching our online Knowledge Base.

  • Joy from Fairchild

    Posted on 2/19/2017

    I just installed a GPS in dash stereo the GPS says no sattilite detected where do I hook up external antenna does this replace radio antenna also there is a slot for as card do I need one

  • Alexander Hrabe from Crutchfield

    Posted on 2/20/2017

    Joy, your radio antenna is not the same as your GPS antenna, which should have been included with your new stereo. Your manual instruct you on which input on your stereo to plug into. Also, keep in mind that if you bought your gear from Crutchfield, you can call Tech Support for free help troubleshooting your system. If you purchased your equipment elsewhere, you can still get expert Crutchfield Tech Support - 90 days-worth for only $30. Check out our tech support page for details.

  • joy from fairchild

    Posted on 3/2/2017

    i installd a in dash radio it has everything even gps gps cant find satillite i got a gps antenna to hook up will this help and where do i plug it into the radio

  • Alexander Hrabe from Crutchfield

    Posted on 3/6/2017

    Joy, your manual should be point out where to plug in the antenna (which, I'm assuming was included?). If you don't see reference to GPS in the manual and you bought your gear from Crutchfield, you can call Tech Support for free help troubleshooting your system. If you purchased your equipment elsewhere, you can call the manufacturer's tech support or you can still get expert Crutchfield Tech Support - 90 days-worth for only $30. Check out our tech support page for details.

  • kevin from bismarck

    Posted on 6/22/2017

    Hi, I just installed a Boss BN965BLC and am not able to get any satellite reception. I have tried mounting the antenna o the dash as well as the outside of the car..still no reception . I wasnt able to hook up the BU camera, reverse wire, or the parking brake wire..could that be the problem?

  • Alexander Hrabe from Crutchfield

    Posted on 6/22/2017

    Kevin, if you bought your Boss stereo from us, you can call Tech Support for free help troubleshooting your system. If you purchased your equipment elsewhere, you can still get expert Crutchfield Tech Support - 90 days-worth for only $30. Check out our tech support page for details.

Great Gear Giveaway



Ask an expert advisor

No pressure, no commission — just lots of good advice from our highly trained staff.

Find what fits your vehicle


Can't find your exact vehicle?

Featured Products