2008 Chevrolet Tahoe
Crutchfield Customer Review (What's this?)
Great tweets for the money!
Pros: Easy installation
Our experts help you pick the ideal gear for your needs.Meet our advisors
Free tech support for the life of your gear.Read about our one-on-one expert help
You may return items that are complete and like new for any reason within 60 days.See the details of our return policy
Earn one point for every dollar you spend and use those points to save on future purchases.Get full details on Crutchfield Rewards
We offer vehicle-specific installation instructions, dash kits, wiring harnesses, and speaker accessories at deeply discounted prices with car stereo and speaker purchases. Available for most vehicles.Learn more
Our customers have trusted us with their business, and they’ve helped us win awards for our service.Check out our most recent awards
The manufacturer’s warranty always applies.See more details
Item # 113ST01 | MFR # KFC-ST01
A pair of Kenwood's KFC-ST01 balanced dome tweeters can make a big improvement in your system's soundstage. The balanced dome design offers wide dispersion for excellent imaging, and this 1" polyetherimide tweeter can handle up to 40 watts RMS. Kenwood includes in-line high-pass filters that maintain the high-efficiency, low-distortion output. Install these tweeters in a good spot, and you'll hear your system come alive with new details.
Installation note: You'll need a pair of our universal backstraps to install these tweeters in the factory locations.
Great tweets for the money!
Donnie, Eufaula, AL
Average Customer Review(s):
Great tweets for the money!
Pros: Easy installation
Sound was good. no complaints.
2016 Kia Soul+ with standard sound system. These were recommended to me by Crutchfield Jenny via the chat window. It took a little ingenuity to get them installed but once I did they worked great. I put them in place of the existing tweeters in the pillars in the dash. I had to take out the factory tweeter and pry out it's mount. That gave me access to the whole area above the vent. This tweeter barely fit into this space. I used a small, thin piece of the foam that came with the KFC-1795PS speakers that I bought at the same time for the doors. I put this foam under the tweeter, then when I pushed car speaker housing parts back together it held the tweeter in nice and tight. Worked great. The wires on the car side were kind of short but if you pay attention they can work. I cut off the connectors that came on the speaker and used my own quick connectors as I didn't have the same ones (same size) that came on the speaker to put on the car side.
Pros: Great sound with factory radio
Cons: none yet
These tiny surface mount tweeters sound great and added needed high frequency sound in my 2008 Honda CRV LX. This vehicle does not come with factory tweeters but I mounted them on top of the dashboard panels that house factory tweeters in the higher end CRV models. Installation was fairly easy but the connectors require a special crimping tool to do it right. I used a standard crimping tool which worked okay but the right tool would have probably been worth the money in retrospect.
Pros: Great sound from tiny surface mount speakers that can fit in many locations in most vehicles.
Cons: The supplied connectors require a special crimping tool. Consider buying this tool to make installation easier.
I found that these speakers are exactly what I paid for. Quality tweeters that are far superior to my factor ones but not quite the best in the world.
Pros: Get what you paid for and definitely better than factory
Cons: Not perfect, that's about it
I wasn't aware that a bracket had to be fab'd. Sort if complicated
Was blown away from the crisp clear sound and for the price can't beat it
Pros: Small and easy to install anywhere great price
Cons: Could use more angles instead of fixed
Great sounding tweets for the price. Easy to install and look clean.
This tweeters are amazing the sound is crystal clear if you like loud music. They don't crack and the sound great. I would recommend this to anyone
Pros: Great sound amazingly clear
Cons: Hooking them up was a bit of a pain but as long as you know how to wire then you good
they are a great value and they sound great for the price. brings out the high end of all types of music. they look great.
Pros: look really good sound great for the price.
Cons: was hopping for just a oem replacement but had to fabricate them in over the top of the existing location
These speakers will leave your ears ringing. Huge improvement over the stock ones that were in there. I would give these speakers a 5 if the mounting bracket wasn't so flimsy. It does work, but it could have been better.
Pros: Good sound, small, kenwood name and price.
Good instructions, nice look, good sound.. Just what I expected!
I use these to replace the A pillar tweeters on a 2000 Sienna Van, it made such an improvement to the sound stage, and the clarity of the highs is quite impressive for the price. Job well done at Kenwood.
These little tweeters sound amazing. You cannot go wrong with these for the price. I paired them with Kenwood 5x7's powered by an Alpine amp for the front doors of my F-150. Really improved the sound! Would definitely recommend these. If the tweeters in the rear doors ever go I will replace them with these.
Pros: Good price, great sound!
Cons: Mounting was a little tricky, would rather have adjustable angles rather than fixed. The mounting brackets could have been better, I wound up not using them and fabricating my own.
Great addition to my truck. Sure they weren't intended for installation in a 40 year old pickup, but a little modification to the mount plates, and done. Amazing how well they work for the price.
Pros: Great sound, easy install.
Cons: mount plates are a little flimsy for anything other than a flat surface. Not a big deal..
After putting in a 12' subwoofer, treble was much needed. I have recently upgraded my entire system, front to back with nothing but kenwood products. Not only was I blown away by the performance of these tweeters but every kenwood product I own. This is a great buy.
This is a very helpful product. I added a pair of them on in my van because my co-axial speakers were aiming at my knees. I ordered a second pair for the back seats, too, but I'm going a different way with that. The only thing is that the mounting angle is a little peculiar. It has to point 20 degrees off the mounting axis. There is some misunderstanding as to the resistance these add-ons contribute to your channel. Do they make your load 2 ohm? A lot of inconsistent answers. Well, after calling Kenwood, and about half of Crutchfield's tech's who differed greatly on their response to that question, I don't think so. It's a 4 ohm nominal load, but the power draw is so small apparently the amp doesn't see them, much. But they work and sound great and are just what you need.
Pros: Good sound up from the knees/Low cost/flexibility
Cons: Some small effect on resistance, maybe.Crutchfield response on September 24, 2014 Adding tweeters to your door speakers will help improve the sound of your music and raise the soundstage up from the floor. But their effect on the system is sometimes confusing. James is correct that the new tweeters will have minimal impact on power and impedance. While it's true that the tweeters are 4 ohm and they're usually being wired in parallel with the door speakers, they don't create a 2-ohm load on the system because they require such a small amount of power to do their work. The actual impact on the impedance load is fairly negligible.
These Kenwood tweeters have brought life back to my worn out system, they are really clear and the sound output is fantastic.
Pros: Easy to install, great sound output, and they are a fairly cheap way to make your system come alive.
Cons: Absolutely none so far.
Despite a recent full Crutchfield radio and sub-woofer amp and 5 speaker upgrade to my Jeep TJ it still lacked a crisp ear level punch. Incorporating these Kenwoods into the mix solved that dramaticly! Quick and easy eye level mount on the A pillar plastic trim and wired quickly to my front speaker with th supplied mounting and wire kit and the high freq sonic void eliminated! Install pic's of these and other components to be posted soon. Great deal for the low cost in this particular case and I recommend a set for all Jeep owners...
Pros: Easy to install and integrate into your system. Good crisp highs..
Cons: Supplied wiring kit not compatible in this application. Required crimp connectors or hand soldered as the best method.
Pros: Makes music sound a lot better
Cons: I wish they had more watts lol
I admit that the time and frustration these caused me were due to my blatant lack of knowledge about speakers in general. I thought all speakers were the same and that it didn't matter what they run off. Boy was I wrong, for starters these tweeters look really nice, they feel pretty good quality and the install took me about 20 minutes per. The sound is good but it would be better if I had known they ran 40 rms, I have them powered by my HU which only puts 22 rms out. So if I had them working off and amp the sound would be great.
Love this tweeters!!!
Pros: great sound and can't beat the price.
Don't waste your money on any other tweeters than these. I paired them with my 6x9 side speakers and 4" front ken woods and the crisp clarity from them are excellent. My neighbors will def come to hate me!
Pros: Clarity!!! Easy to mount anywhere
Install was easy. I mounted them on the B pillar of a Ford F-150 crew cab. The sound is great you just have to spend some time getting the X-over point right.
Pros: Easy installation. Good sound.
Cons: Takes some time to get the best sound out of them.
Easy install and crisp sound. Made a big difference.
Item wasn't very good! To small barely any sound was produced!
Pros: Sleek looking
Cons: Small, barely any soundCrutchfield response on October 2, 2012 We forwarded this review to our Technical Support team for follow-up. Lifetime tech support comes with every Crutchfield purchase.
|Tweeter Design||1" Balanced Dome|
|Parts Warranty||1 Year|
|Labor Warranty||1 Year|
|Sensitivity (1W at 1 meter)||90|
|Sensitivity at 2.83 volts||N/A|
|Frequency Response||5000 - 25k Hz|
|Minimum RMS Wattage||2|
|Maximum RMS Wattage||40|
|Peak Power Handling (Watts)||160|
|Top-mount Depth (Inches)||0 3/4|
|Bottom-mount Depth (Inches)||N/A|
|Cutout Diameter or Length (inches)||1 7/8|
PEI Dome Tweeters: The 1" dome tweeters are made of Poly-Ether-Imide (PEI); PEI is a polymer film that produces a wide soundstage for superior imaging.
Crossover: The 6 dB/octave crossovers are mounted inside the surface mount housings.
Mounting: The tweeters are surface mounted in the angled housing (approximately 20°) and have these dimensions:
|Mounting Depth||0.7" (mounting screw depth)|
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere. That's because we have our own in-house Product Research team. They verify what’s in the box, check the owner's manual, and record dimensions, features and specs. We stay on top of new products and technologies to help people make informed choices.
I choose this item because the customer rep suggested these [ Cierra Feb 28, 2017 ]
Good reviews and pricing [ Eugene Dec 12, 2016 ]
excellent items at great prices [ Steve Nov 16, 2016 ]
Wanted small tweeters and these should fit on the dash where the factory tweeters would have gone on my Honda CRV. [ John W. Oct 15, 2016 ]
I currently have a Kenwood eXcelon DNN991hd HU so I figured I would try out all of the Kenwood lineup. [ Patrick May 03, 2016 ]
I like my highs just as much as my lows! [ Christopher Apr 01, 2016 ]
I like Kenwood clarity. Good fit for my set-up. [ Marvin K. Dec 05, 2015 ]
For additional details on fit or installation please contact an Advisor by phone (1-800-324-9695) or online chat. They will be able to pull up your vehicle and give you the details on if this will fit and what you will need for an installation in your vehicle. [ Kenny Jun 14, 2016 ] Staff
You need a cross over in order to separate the mids and highs for the tweeters to work. [ lionel May 08, 2015 ]
Make sure you are using a crossover that has the proper ohms Ohm requirements are lost in product spec sheet [ 69junk May 07, 2015 ]
If you purchased the product from Crutchfield, feel free to contact our Tech Support team. Our toll-free Tech Support number is printed on your invoice, and is also available under the "My Orders" tab in the "My Account" section of our website. If you did not purchase the unit from Crutchfield, then you may want to contact the manufacturer. You can also post your question in our forums: http://community.crutchfield.com. Or try our online support center: http://crutchfield.custhelp.com/app/answers/list/kw/. [ Jeff May 07, 2015 ] Staff
Don't know, I sold the car. Sorry [ DARREN Apr 01, 2015 ]
1 1/2" [ 69junk Apr 01, 2015 ]
I mean one inch and half. [ lionel Apr 01, 2015 ]
I think about 1and half. [ lionel Apr 01, 2015 ]