Skip Navigation

Rosen DP-1030

Backup sensor kit for Rosen navigation receivers

Item # 135DP1030

This item is no longer available.

Shop all Backup Cameras


Our take on the Rosen DP-1030

Add an extra measure of safety when you're backing up in tight spots. The DP-1030 backup sensor kit connects to your Rosen navigation receiver, and alerts you when an object gets too close to the back of your vehicle. The kit includes four sensors, a wiring harness, an interface for your Rosen receiver, a 24.5' cable, and a special drill bit to aid installation. Warranty: 1 year.

What's in the Box:

  • Main sensor module (with attached 7" cable terminated by a proprietary multi-pin connector)
  • 24.5' Connector cable (with a proprietary multi-pin connector on each end)
  • 4 Sensors (with attached 8' cable terminated by a proprietary 2-pin connector)
  • 3/4" Metal hole-saw bit
  • Installation Guide

Hands-on research

Product Research


Overview: The Rosen Backup Sensor Kit (DP-1030) is compatible with specific Rosen & Car Show Multimedia Navigation head units which feature a radar-sensor port. The Rosen Backup Sensor Kit includes a hideaway sensor module, a 24.5' connector cable, and 4 exterior sensors. The hideaway sensor module is mounted inside the vehicle and connected to your Rosen or Car Show Multimedia Navigation head unit using the supplied 24.5' connector cable. The 4 exterior sensors plug into the hideaway module and are mounted outside the rear of the vehicle (symmetrically on the bumper surface). Once installed, the Rosen Backup Sensor Kit will send an audible warning through your vehicle's audio system, if your vehicle backs up to close to an object.

Sensor Mounting: The Rosen Backup Sensor Kit comes supplied with a 3/4" metal hole-saw bit that attaches to a cordless or electric drill (not included) to cut out openings for the 4 exterior sensors in your vehicle's bumper. Once these holes are cut-out in your vehicle's bumpers, the exterior sensors clip into place.

Note: When installed, the sensor should point straight back, not to the sides, up, or down.


  • Hideaway Sensor Module: Width = 5.5625", Height = 1.125", Depth = 3.1875"
  • Exterior Sensors: Diameter = 0.875", Depth = 0.9375"

Our Product Research Team

At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere. That's because we have our own in-house Product Research team. They verify what’s in the box, check the owner's manual, and record dimensions, features and specs. We stay on top of new products and technologies to help people make informed choices.