chassis is component-sized (17" wide) and made from durable black metal with padded feet.
Each set of speaker outputs has an on/off switch so any combination of
connected speakers can be played at any given time.
Protection Switch: The impedance
protection switch on the front of the
unit safeguards the
receiver or amplifier even when all 4 pairs of speakers are playing (4 pairs of
8-ohm speakers will present a 4.5-ohm load to the receiver or amplifier).
Note: You will need to
activate the "Protection" switch whenever the overall system impedance
might fall below 4 ohms. It is recommended to verify that the receiver
or amplifier is capable of driving a 4-ohm load.
Protection: This speaker selector is equipped with a manual override for the
protection circuit that enables you to defeat the front panel protection switch
and maintain constant impedance protection. This will safeguard your amplifier
from being overdriven due to accidental or improper use.
Terminals: There are four removable speaker output terminal blocks and one
removable speaker input terminal block. These
connectors make it easier to wire the speakers to the selector.
Each terminal block can accommodate up to 12 gauge wire.
Labels: Included are 72 pre
printed and 6 blank label stickers for easy identification of the front panel controls.
- Frequency Response: 20Hz-20kHz
Handling: 250 watts per
channel RMS at 8 ohms