In addition to manual bass and treble settings (-6dB to +6dB @ 100Hz and 10kHz),
this unit also has six selectable preset tone control and loudness setting
combinations. Each of the sound modes may be adjusted to your preference and
stored in memory. The preset Custom Equalizer modes are:
- Rock: Bass =
+3, Treble = +1, Loudness = On
- Classic: Bass
= +1, Treble = -2, Loudness = Off
- Pops: Bass =
+4, Treble = +1, Loudness = Off
- Hip Hop: Bass
= +2, Treble = 0, Loudness = On
- Jazz: Bass =
+2, Treble = +3, Loudness = Off
- User: Bass =
0, Treble = 0, Loudness = Off
When you are using the KD-G110 with factory speakers (or those rated to less
than 50 watts peak), the Amplifier Gain Control can limit the amount of power
being sent to those speakers. When the Amp Gain Control is set to "low", the
volume control ranges from 0 (minimum) to 30 (maximum). When using speakers
rated higher than 50 watts peak, you can set the Amp Gain Control to "high", and
the volume control will range from 0 to 50.
Preferred Setting Mode: By activating the Preferred
Setting Mode (PSM), you can set the clock, switch between US standard and
European tuning spacing, and set the Amplifier Gain control (high/low).
This model is equipped with JVC's proprietary HS-II tuner. You can set up to 18
FM and 6 AM stations as presets. Presets can be set manually, or automatically
using Strong-station Sequential Memory (SSM). If an FM stereo broadcast is hard
to receive, you can manually switch the tuner to "Mono" operation.
You can directly access CD tracks 1-12 by pressing the station preset buttons.
If a preset button is pressed for less than 1 second, the track corresponding to
the number on the preset button is selected (for tracks 1-6). When a preset
button is pressed for more than 1 second, the track corresponding to the number
above the preset button is accessed (for tracks 7-12).
a CD, you can switch between the clock display and the CD elapsed time display
(the track number always appears). While listening to the radio you can switch
between the clock display and the station frequency display. When you press the
Display button during power off, the unit will turn on, display the clock for 5
seconds, then shut off. This can be done with the ignition on or off.