Why Choose Crutchfield?
Great gear and expert advice
Our experts help you pick the ideal gear for your needs.Meet our advisors
Free tech support for the life of your gear.Read about our one-on-one expert help
You may return items that are complete and like new for any reason within 60 days.See the details of our return policy
Earn one point for every dollar you spend and use those points to save on future purchases.Get full details on Crutchfield Rewards
Deep discounts on car installation gear
We offer vehicle-specific installation instructions, dash kits, wiring harnesses, and speaker accessories at deeply discounted prices with car stereo and speaker purchases. Available for most vehicles.Learn more
Trusted since 1974
Our customers have trusted us with their business, and they’ve helped us win awards for our service.Check out our most recent awards
The manufacturer’s warranty always applies.See more details
Rockford Fosgate Power HX2 RFR3110
10" 2-ohm Dual Voice Coil Component Subwoofer
Item # 575RFR3110 | MFR # RFR3110
This item is no longer available.
Our take on the Rockford Fosgate Power HX2 RFR3110
The sonic boom that just rattled the ground sure, it might have been a passing jet fighter, but it also might have been a single blast from Rockford Fosgate's top-of-the-line subwoofer. The 10" RFR3110 blasts off with up to 2,000 watts of peak power. And, while you'll only hear those jets occasionally, this Power HX2 blaster puts you in the audio cockpit any time you fire up your system.
The inverted, heavy-duty cone is made of FIBERlock, a high performance coated paper. For extra rigidity and durability, it's been dipped into a "high solids" solution. The result is a cone so strong that it can support the weight of a grown man. A Santoprene rubber surround helps the cone's extended excursion while fighting off enemies like bad weather and road hazards.
The oversized magnet structure (18-3/4 pounds) helps to generate the highest power handling of any Rockford Fosgate woofer. A CONsealer gasket guards against annoying air leaks around the woofer frame. With the 2-ohm dual voice coil design, you can hook up this sub to meet your system's demands.
Note: If you are wiring this DVC sub for lower impedance, make sure that your amp is compatible. Most car amplifiers are stable down to 2 ohms in standard mode, or 4 ohms in bridged operation.Details:
- FIBERlock cone with Santoprene rubber surround
- frequency response 28-400 Hz
- power range 150-1,000 watts RMS (500 watts per coil)
- peak power 2,000 watts
- sensitivity 83 dB SPL
- dual voice coil design (two 2-ohm coils)
- top mount depth 6-1/2"
- sealed box volume 0.625 cubic feet
- ported box volume 0.75-1.75 cubic feet
- Recommended Q-Logic Box Type: 1, 2, 3
- 1-year warranty
What's in the Box:
- One 10" woofer
- ConCealer rubber gasket
- "Team RF" sticker
- Installation & Operation manual
Features and Specs
|Impedance||1 ohm or 4 ohms|
|Surround Material||Santoprene rubber|
|Ideal Sealed Box Volume (cubic feet)||0.625|
|Ideal Ported Box Volume (cubic feet)||1|
|Port diameter (inches)||3|
|Port length (inches)||13.25|
|Dual Voice Coil||Yes|
83 dB at 1 watt
|Frequency Response||28 - 400 Hz|
|RMS Power Range (Watts)||150-1000|
|Peak Power Handling (Watts)||2000|
|Top Mount Depth (inches)||6 1/2|
|Bottom Mount Depth (inches)||N/A|
|Cutout Diameter or Length (inches)||9 3/16|
|Parts Warranty||1 YEAR|
|Labor Warranty||1 YEAR|
Dual Voice Coils: For increased system flexibility, the woofer has two 4" 2 ohm voice coils. When the voice coils are wired in parallel with each other, the woofer presents a 1 ohm mono load. When the voice coils are wired in series with each other, the woofer presents a 4 ohm mono load. In addition, each coil may be connected to a different amplifier channel and each channel will see a 2 ohm load.
FIBERLock Cone: This new high performance paper stock is a combination of natural and regenerated cellulose fibers interlaced with a third, longer fiber. The three natural fibers are chemically fused together with a blend of three interactive binding agents. The extremely high fibril strength and toughness comes from the combination of all six of these component layers. FIBERLock is light, tough and it's proven to have superior sound quality and incredible durability. The cone is then treated with a Thermally Cured Acrylic Emulsion that seals the cone body for exceptional damping and even greater rigidity, resulting in industrial strength power handling.
BART Santoprene Rubber Surround: The BART surround has a large roll to assure maximum cone travel. By increasing cone travel, the BART surround allows the woofer to produce more bass. Santoprene is a durable and temperature tolerant rubber material that provides the consistent support needed for linear speaker cone motion. In addition, the damping capabilities of santoprene eliminate the transmission of sonic disturbances between the cone and the frame of the speaker, improving the accuracy of the woofer's low frequency response.
Punch LX Cast Basket: The woofer uses a cast aluminum frame that reduces frame flex and offers increased stability over a stamped steel frame. This frame offers the lowest coloration of sound due to the added strength. To help prevent the spider from hitting the bottom of the basket ("soft bottoming"), the LX Cast basket features a deep step that moves the physical boundaries of the basket further away from the spider; this allows the cone far greater travel and, therefore more bass, without soft bottoming.
Aluminum Formers: The aluminum formers allow the voice coils to efficiently dissipate heat, resulting in improved power handling.
Dual Laminated Progressive Flat Spider: The dual laminated progressive flat spider provides a very strong suspension for the woofer. A secondary spider is fused to the primary spider near the critical voice coil bonding point. The combination of the two spiders, in addition to the progressive rolls in the spiders, provides the ultimate in linear control for high excursion capability.
Hyper-Extended Pole Piece: The pole piece is extended in length to lower distortion and provide better low frequency response by operating the voice coil in a linear fashion throughout its travel in the magnetic field.
Punch LX Long Xmax Voice Coils: The L-xtended winding coils allow the voice coil to stay in the magnetic gap longer, resulting in less distortion and more control. Combine the L-xtended coil with the hyper-extended pole piece and the result is a huge magnetic sweet spot and deeper, louder, cleaner bass.
Vented Bumped Back Plate: The back plate has been bumped to allow the woofer more room for excursion without bottoming out. Additionally, "Aerovent" cooling efficiently and quietly circulates cool air around the voice coil using a back plate that is vented with a radiused aerodynamic back vent. By keeping the voice coil cooler, power handling is improved.
Rubber Magnet Boot: A black rubber boot covers the exposed edge of the magnet structure to improve the cosmetics of the woofer and protect the magnet during installation. The rubber boot looks great when the woofer is mounted in an enclosure with a window that allows you to see the back of the woofer.
CONsealer Gasket: A newly designed front gasket conceals mounting screws and provides an airtight seal between the woofer frame and the mounting surface. A better seal increases the amount of bass due to the elimination of air leaks.
Binding Posts: The woofer has two sets of 5-way platinum binding posts, one set for each voice coil. The binding posts will accept banana plugs, dual banana plugs, spade connectors, pin connectors and bare wire.
Enclosure Compatibility: This woofer can provide extended bass in sealed and ported enclosures (see the "Specifications" section for more information on enclosures).
Recommended Sealed Box Volume: Rockford Fosgate recommends a 0.625 cu/ft sealed enclosure.
Recommended Ported Box Volume: The ported box volume range recommended by Rockford Fosgate is 0.75 cu/ft to 1.75 cu/ft. Within this range, the ideal size recommended by Rockford Fosgate is 1.0 cu/ft, so this is the enclosure recommended by Crutchfield. One 3" diameter x 13-1/4" long port, tuned at 35Hz, should be used with a 1.0 cu/ft enclosure.
Power Handling: The woofer has two 2 ohm voice coils, and each coil can handle up to 500 watts RMS (1000 watts peak).
Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere. That's because we have our own in-house Product Research team. They verify what’s in the box, check the owner's manual, and record dimensions, features and specs. We stay on top of new products and technologies to help people make informed choices.