Specifications & Dimensions
Cone Design: The woofer cones are ceramic filled polypropylene
and use rubber surrounds. The aluminum phase plug mechanically smoothes the response
and acts as a heat sink for the voice coil, reducing power compression.
Tweeter: The 1" titanium, Ferrofluid cooled dome tweeter's
light yet rigid diaphragm and over hung voice coil, combined with a computer
optimized magnetic circuit produce an extended high frequency response that
remains distortion free even at extreme volume levels. The front baffle is
designed to eliminate mid and high frequency diffractions, maximizing three
Crossover Network: The crossover is a 2-way acoustical fourth
order Linkwitz-Riley type with a 24 dB/octave slope. Tight tolerances were used
when choosing the crossover components; heavy multi-laminated iron cores are used
for large value inductors, high gauge wire air core inductors are used for medium
and small values, all the capacitors are low loss and film capacitors are used for the
midrange and treble frequencies. The tweeter and top woofer are crossed over at
1,800 Hz, the bottom woofer plays only 800 Hz and below.
Cabinet: The cabinet is an integral part of speaker design and
has a dramatic effect on the overall sound of a speaker. PSB's 7-layer laminated
construction results in a solid, acoustically inert enclosure. The side and top
panels are curved for added stiffness, with a high-gloss lacquer exterior. Internally
the cabinet has two separate chambers, each with its own port on the rear panel.
Port Cover: There are two ports on the rear panel, one for
each of the internal chambers. One port cover is included to seal a port (if
necessary), thereby changing the bass tuning characteristics of the speaker to
correct the interaction with the room. If needed, additional port covers can be
obtained from PSB for a nominal fee.
Binding Posts: The dual binding post input terminals are located
on the lower rear of the speaker cabinet. The two sets of binding posts are shorted
together by a gold-plated jumper. With the jumper removed the Imagine T can be
bi-wired or bi-amplified. The binding posts will accept spade connectors, single
banana plugs, pin connectors, and bare wire up to 8 gauge.
Leveling Feet: The Imagine T includes two sets of leveling
feet; the rubber covered feet are used on a hard surface and add approximately
1/2" to the height of the speaker, the carpet spikes add approximately 1"
to the height.
Specifications & Dimensions
- On Axis @ 0°: 38-23,000 Hz (+/-3
- On Axis @ 0°: 42-20,000 Hz (+/-1.5
- Off Axis @ 30°: 42-10,000 Hz (+/-1.5
- Low Frequency Cutoff -10 dB: 35 Hz
- Anechoic Chamber: 88 dB
- Typical Listening Room: 90 dB
- Width (body): 7-1/2"
- Width (w/ feet): 8-3/8" (the feet
mounted to the bottom of the cabinet are wider than the body
of the speaker)
- Height: 37-1/8" (installing the
rubber tipped leveling feet or carpet spikes, one of which
should be used for any application, will add to the overall
- Depth: 13-3/4" (including the binding
Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere. That's because we have our own in-house Product Research team. They verify what’s in the box, check the owner's manual, and record dimensions, features and specs. We stay on top of new products and technologies to help people make informed choices.