Chat
Contact us
Close contact box
Connect ID #
777 186 387 4
Connect ID #
777 186 387 4
Don't wait on hold. We'll call you back when it's your turn to talk with the next available .
Please enter your name  
Please enter your phone number  
Please enter a message  

Calls may be recorded for training and quality control purposes.

We are located in Virginia USA.

Thank you. We will be calling you .
We're sorry. We have encountered a problem.

How to install a car navigation system

Get wired properly so you don't get lost

In a nutshell: In this article, we'll cover some of the additional steps needed to install an in-dash navigation receiver beyond those required for a regular car stereo. We'll talk specifically about the GPS antenna and extra wire connections.

For the most part, installing an in-dash navigation receiver is quite similar to installing regular touchscreen stereos. But there are a couple of additional wrinkles: a GPS antenna and a reverse-direction sensor. 

This article will focus on these extra steps for the navigation receiver's installation. After you've read this article, refer to our Car Stereo Installation Guide for full details about stereo installation.  

At the end of the article we'll talk about add-on navigation modules.

Alpine INE-W970HD digital multimedia navigation receiver

In-dash navigation systems, like the Alpine INE-W970HD, provide you with large displays and easy touchscreen controls.

GPS antenna installation

There are a couple of simple rules guiding the external GPS antenna that comes with in-dash navigation receivers. The first is that you shouldn't ever cut or otherwise modify the antenna in any way. The other is that it needs to be in constant contact with the GPS satellites which orbit the earth, so it should be mounted in a way that there won't be a lot of interference with its signal.

In most cases, you can mount the GPS antenna near the top of the underside of your dash (behind or above the receiver). Satellite signals are so strong and reliable these days that this should be sufficient to maintain reliable reception. It also serves to keep the antenna out of sight.

Alternatively, our tech support experts recommend mounting the GPS antenna either on the dash or along the rear deck. As long as it has a clear path to the sky and is not too close to A-pillars or a 2-way antenna, it should work. 

However, you should consider mounting the antenna on the exterior of your vehicle if:

  • you have a wired rear defroster
  • you have metallic window tint
  • you have a solar reflective window
  • you have a windshield-mounted radio antenna

The GPS antenna should also be as level as possible and maintain a solid connection to its attached metal plate or sheet, if there is one. There will typically be some sort of adhesive involved to keep the antenna in place. You'll then need to route the antenna wire to the rear of the receiver along the dashboard or floorboard or through a window or door seal. 

Wire connections

Receivers with a video screen require a couple of extra wire connections that aren't needed for non-touchscreen stereos. Let's take a look at each one. 

Parking brake wire connection

For safety reasons, any video screen in the front of the car must be attached to the parking brake wire. This applies to GPS systems too. Some of the more advanced navigation functions are disabled while the vehicle is in motion. If you want to look up a phone number or change the default settings of the unit, you'll need to pull over first. In rare cases, a connection to the foot brake may also be required.

Reverse signal wire connection

Many navigation systems also connect to the vehicle's reverse (or back-up light) signal wire — this connection tells the navigation system when the vehicle is traveling in reverse. If this wire is not hooked up, then the vehicle direction will not track properly, and the navigation system won't be able to do its job.

The most common way to do this is to connect to the reverse light wire right at the tail light. You'll need to check each wire that goes into the tail light with a multimeter. Connect the multimeter to a wire, have someone put the car in reverse (while keeping the brake engaged, of course), then see if you get a 12-volt reading. Repeat this process with each wire until you find the right one. (Note: If you get a 12-volt reading, make sure it's because you've found the reverse wire, not the brake wire. You'll know it's the brake wire if you get a reading as soon as the brake is pressed.)

The reverse wire can sometimes be found under the dash or under the hood, but you'll have to consult your vehicle's wiring diagram carefully in order to identify it correctly. Tapping into it at the taillight tends to be much easier.

Crutchfield can help

Our highly trained Technical Support staff can provide parking brake and reverse wire information for most vehicles. They're available seven days a week (have your invoice handy when you contact us). Even if the information is not available for your vehicle, they can still help you figure out which wires are the ones you need.

We recommend Posi connectors for wire connections

Posi-Product™ connectors offer a quick and secure twist-on connection for wires, and they can be re-used. For the connections we're talking about here, you'll want a package of Posi-Tap™ connectors. They let you tap into an existing wire without cutting it. This is our favorite way to get strong connections fast. You can also try soldering or crimping if you feel more comfortable with those methods.

How to use Posi-Tap connectors

Here is our step-by-step guide to using Posi-Tap connectors when you need to tap into a wire in your vehicle. 

Posi-Tap wiring connector
Step 1

Each Posi-Tap wire connector splits into three separate pieces: large cap (tap end), barrel with conductor point, and small cap (accessory end).

Posi-Tap wiring connector
Step 2

Insert the tap wire into the large cap and hand tighten into the barrel. The conductor point pierces the tapped wire without compromising its conductive integrity.

Posi-Tap wiring connector
Step 3

Slide the stripped end of the accessory wire through the small cap.

Posi-Tap wiring connector
Step 4

Tighten the small cap into the end of the barrel, and you're ready to go.

Remote-mount navigation systems

A remote-mount nav system consists of a separate navigation module (with an external antenna) that must be connected to a compatible touchscreen car stereo. Drivers interface with them the same way they would an in-dash system. These are not as common today, but they're just as effective as in-dash systems, provided their mapping data is up to date and they're properly connected.

The navigation module is basically a box that needs to be installed somewhere out of the way. Today's navigation modules are typically compact enough to be installed in the glove compartment, often with some sort of velcro fasteners to keep them in place. They usually have a memory card slot or USB input to receive map updates. The GPS antenna runs off the module, and can usually be mounted on the dash. The module requires battery and ground connections, just like the stereo.

Pioneer AVIC-U280

Newer add-on navigation modules are compact enough to fit into the glove compartment of most vehicles.

Need help choosing a navigation receiver? 

Installing an in-dash navigation stereo only requires a couple of extra steps beyond any other stereo installation. If you're ready to start shopping for your own navigation receiver, use our vehicle fit tool to see which models will work in your car. 

If you have any questions, contact our advisors. They're always happy to help and will make sure you have everything you need for the installation. 

Please share your thoughts below.

  • Andy from San Mateo

    Posted on 7/2/2020

    I have navigation on my current OEM in dash unit. Is there any way to keep that GPS antenna with a new unit?

    Commenter image

    Dominic DeVito from Crutchfield

    on 7/3/2020

    Hi Andy - thanks for reading. The answer is a very strong "maybe," but it really depends on your vehicle and the aftermarket stereo you're installing. There are a number of adapters from iDatalink that can allow you to retain your OEM GPS antenna, but they're made for specific applications. Give us a call or chat online and one of our Advisors can help you sort through your available options, if any.
  • TDUONG from Garden Grove

    Posted on 1/12/2020

    Hi, Can you tell me how to hook up the brake line from the navigation system to the car? Thank you

    Commenter image

    Dominic DeVito from Crutchfield

    on 1/12/2020

    Hi TDUONG - If you bought your navigation system from Crutchfield, one of our Tech Support staff will be happy to walk you through your connection questions for free 7 days a week - simply call the number for our Tech Support that was provided with your order invoice and they'll take care of you. If you didn't get your gear from Crutchfield, you can still take advantage of our very helpful Tech Support by purchasing 90 days worth from us here.
  • Silvia Cubero from Miami

    Posted on 1/26/2019

    Where can i get a chip/usb to update the navigation system on this touchscreen system?

    Commenter image

    Dominic DeVito from Crutchfield

    on 1/28/2019

    Hi Silvia - if your car has a factory navigation system, you'll have to check with a dealer about update options. If it's an aftermarket system, check the website of the stereo brand to see if updates are available (usually as a download, which you'll have to put on a USB stick and then transfer to the stereo). Not every stereo manufacturer offers updates, however. If you bought your touchscreen stereo from Crutchfield, one of our Tech Support people will be happy to help you out if you get in touch.
  • Commenter image

    Alexander Hrabe from Crutchfield

    Posted on 6/22/2017

    Kevin, if you bought your Boss stereo from us, you can call Tech Support for free help troubleshooting your system. If you purchased your equipment elsewhere, you can still get expert Crutchfield Tech Support - 90 days-worth for only $30. Check out our tech support page for details.

  • kevin from bismarck

    Posted on 6/22/2017

    Hi, I just installed a Boss BN965BLC and am not able to get any satellite reception. I have tried mounting the antenna o the dash as well as the outside of the car..still no reception . I wasnt able to hook up the BU camera, reverse wire, or the parking brake wire..could that be the problem?

  • Commenter image

    Alexander Hrabe from Crutchfield

    Posted on 3/6/2017

    Joy, your manual should be point out where to plug in the antenna (which, I'm assuming was included?). If you don't see reference to GPS in the manual and you bought your gear from Crutchfield, you can call Tech Support for free help troubleshooting your system. If you purchased your equipment elsewhere, you can call the manufacturer's tech support or you can still get expert Crutchfield Tech Support - 90 days-worth for only $30. Check out our tech support page for details.

  • joy from fairchild

    Posted on 3/2/2017

    i installd a in dash radio it has everything even gps gps cant find satillite i got a gps antenna to hook up will this help and where do i plug it into the radio

  • Commenter image

    Alexander Hrabe from Crutchfield

    Posted on 2/20/2017

    Joy, your radio antenna is not the same as your GPS antenna, which should have been included with your new stereo. Your manual instruct you on which input on your stereo to plug into. Also, keep in mind that if you bought your gear from Crutchfield, you can call Tech Support for free help troubleshooting your system. If you purchased your equipment elsewhere, you can still get expert Crutchfield Tech Support - 90 days-worth for only $30. Check out our tech support page for details.

  • Joy from Fairchild

    Posted on 2/19/2017

    I just installed a GPS in dash stereo the GPS says no sattilite detected where do I hook up external antenna does this replace radio antenna also there is a slot for as card do I need one

  • Commenter image

    Alexander Hrabe from Crutchfield

    Posted on 8/31/2015

    Steve, you can try searching our online Knowledge Base.

Max. 1500 characters. *Comment is required  
*Name is required  
*Email is required  
Please complete this input.  

Your email address will not be published. Comments will display after being approved by our moderators. Comments may be edited for clarity.

Looking for
gps navigation?

GPS Navigation Shop our selection

Find what Fits your vehicle

Remove

Checking fit...

Compare the sound