Skip Navigation

Metra VT-GMRC-01 Wiring Interface

Install a new car stereo and retain factory door chimes and audible safety warnings in select GM vehicles without OnStar®

269 Reviews | 5 questions - 15 answers

Find what fits your vehicle

 
 
 
 

Can't find your exact vehicle?

Item # 120GMRC01

This item is no longer available.

Shop all Factory System Adapters

New model available

Overview

Our take on the Metra VT-GMRC-01 Wiring Interface

Problem: Installing an aftermarket receiver in many late model GM vehicles means losing the chime that warns the door is open, along with audible safety warnings.

Problem: Installing an aftermarket receiver in many late model GM vehicles means losing the chime that warns the door is open, along with audible safety warnings.

Solution: Metra's VT-GMRC-01 GM Class II Data Bus Interface lets you replace the factory receiver in these vehicles and keep the door chime and all audible safety warnings.

Hook the VT-GMRC-01 to your aftermarket radio, mount the module in a location where the chime can be heard, and plug it into the existing factory plug. Get the great sound you want, and keep all important safety features intact. The VT-GMRC-01 will not work with OnStar equipped vehicles. 1-year warranty.

Important Note: Because your vehicle is factory-equipped with a special sound system, you will need to purchase this VT-GMRC-01 interface in order to keep your factory door chime (needed to keep audible safety warnings functioning) while providing a switched 12-volt power source for your new radio. If you do not use a compatible interface when you replace your factory radio, you will disable the audible warning system in your vehicle. Crutchfield cannot provide a free wiring harness for your vehicle, and we strongly recommend that you use the recommended interface when replacing this vehicle's factory radio. Failure to do so may result in serious injury or death.

Note: Most vehicles will require additional installation parts — please identify your vehicle if you haven’t done so. You can also call an Advisor for more information.

Good product

Monk, Nashville , TN

What's in the Box:

  • GM Class II Data Bus Interface
  • 24" Wiring harness (w/ a white 10-pin female connector on one end and a gray 24-pin male connector on the other end)
  • Installation Instructions
Reviews

Metra VT-GMRC-01 Wiring Interface Reviews

Average Customer Review(s):

(269 Reviews)
rewards card
Great Gear Giveaway

Submit a review and enter to win a $350 rewards card

Review this product

Thanks for submitting your review

Most reviews are processed and published within 5 business days. You will receive a confirmation email once your review has been published.

Your Review

Use the stars below to rate the overall product on a scale of 1-5
1500
Upload your photos

Not visible. Email associated with order.
(e.g., Charlottesville, VA)

Additional Fields (optional)

500
500

By submitting this review, you agree to our terms and review guidelines.

Filter by rating

Customer photos


<< >>
Details

Hands-on research

Product Research

Features

Compatibility: The Axxess GMRC-01 is designed for use in select 2000-2011 GM vehicles with non-amplified factory systems (or when replacing the factory amplified system) and without OnStar.

Make Model Year
Buick Allure 2005-2009
Century 2004-2005
Lacrosse 2005-2009
Rainier 2004-2007
Rendezvous 2002-2007
Terraza 2005-2008
Cadillac Escalade/Escalade Ext 2003-2006
Chevrolet Avalanche 2003-2006
Cavalier 2000-2005
Colorado 2004-2009
Corvette 2005-2011
Express Van (full-size) 2003-2007
Impala 2000-2005
Malibu 2001-2005
Malibu Classic 2004-2005
Monte Carlo 2000-2005
Silverado 2003-2006
Silverado Classic 2007
SSR 2003-2006
Suburban 2003-2006
Tahoe 2003-2006
Trailblazer 2002-2009
Uplander 2005-2008
Venture 2000-2005
GMC Canyon 2004-2010
Envoy 2002-2009
Savanna Full-Size Van 2003-2007
Sierra (Classic) 2003-2007
Yukon/Yukon XL/Deanli 2003-2006
Hummer H2 2003-2007
H3 2006-2009
Isuzu I290 2007-2008
I280 2006
I370 2007-2008
I350 2006
Oldsmobile Alero 2001-2004
Bravada 2002-2004
Intrigue 2002
Silhouette 2000-2004
Pontiac Aztec 2001-2005
Grand Am 2001-2005
Grand Prix 2004-2008
Montana 2000-2005
Sunfire 2000-2005
SAAB 9-7x 2005-2009
Saturn Relay 2005-2007

Note: Please consult Crutchfield's Outfit My Car to see if your vehicle is compatible and what additional accessories will be needed.

Retained Features: The GMRC-01 provides +12-volt accessory output, retains warning chimes, and retains R.A.P. (retained accessory power).

  • +12V Accessory Output: In many GM vehicles, there is no 12-volt accessory wire in the factory harness, which requires the installer to run an accessory wire to the fuse box or underneath the steering column when installing an aftermarket radio. The GMRC-01 is designed to provide a 12-volt/10-amp switched accessory output (red wire).
  • Warning Chimes: The GMRC-01 retains factory warning chimes through the use of an on-board speaker.
  • Retained Accessory Power (R.A.P.):  The ignition power source of most GM vehicles keeps the radio on until one of the doors is opened. This feature is called the R.A.P. (retained accessory power). The GMRC-01 is designed to retain this feature.

10-Pin to 24-Pin Harness: The wiring harness has a white 10-pin female connector (4 pins present) on one end and a gray 24-pin male connector (14 pins present) on the other end. The 10-pin connector plugs into the GMRC-01 and the 24-pin connector interfaces with the existing factory plug. The harness also includes 14 bare wires that will need to be hardwired to your new aftermarket radio's harness.

Wire Color Function
Red +12V Accessory
Yellow +12V Constant
Black Ground
Orange Illumination
Orange/white Dimmer
Blue/white Amp turn-On
White Left Front Speaker +
White/black Left Front Speaker -
Gray Right Front Speaker +
Gray/black Right Front Speaker -
Green Left Rear Speaker +
Green/black Left Rear Speaker -
Purple Right Rear Speaker +
Purple/black Right Rear Speaker -

Our Product Research Team

At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere. That's because we have our own in-house Product Research team. They verify what’s in the box, check the owner's manual, and record dimensions, features and specs. We stay on top of new products and technologies to help people make informed choices.

Accessories
Q & A

Customer Q&A

5 questions already asked

I am not 100% if it will work but it should. You just have to connect to radio and then a power ground and signal wire if I recall, been a little while since I installed to remember exactly what it took. Best of luck to you, BTW great truck wish 8.1 was still made. [ AARON E  Jun 18, 2014 ]
Zeb I installed this kit with a Kenwood system in my 2006 Chevy Colorado Crew cab 3.5 l about a year ago and it works fine. I recommend cutting the trace for the chime to have a lower volume since it was rather loud before that. The only thing I noticed and I am not sure if this is because of this kit or the Kenwood but my key less entry is sometimes slow to allow me to lock the doors when exiting the car. This it is little concern to me since I prefer to use the lock button when exiting my vehicle. Like you I do not have Onstar or steering wheel controls. [ GARTH P  Jun 18, 2014 ]
It sounds like it is the right option for you. [ FRANK  Jun 18, 2014 ]
I don't think you will need this for your truck. It is meant to allow the door chime and warnings that come through the stereo if you have the on star system. Hope this helps. [ CHRIS  Jun 18, 2014 ]
It works in my 1500. This is the second one of the buzzers I've had. The first one died. I replaced it when I upgraded to my present receiver. New one has been fine over a year now. Be careful not to pull you a/c lines tight and double check that their plugs are tight and straight just before you close it up. GMC for 2004 has an issue with the a/c changing to heat randomly. They say it's these connections. It's really grease dripping on the control servo but there could be more then one problem. This has plaged General Motors on a few models for several years right in that time frame. [ TERRY  Jun 17, 2014 ]
It should work fine because it hooks up to the back of the head unit. In my 2003 chevy silverado 2500hd the key reminder beep was installed in the factory radio. [ RAYMOND O  Jun 17, 2014 ]
I'm not positive but I would guess no. My 2005 Silverado 1500 does have steering wheel controls. I would speak to a Crutchfield representative to make sure though. [ Rich  Jun 17, 2014 ]
Unfortunately we can't answer specifics about vehicles that are sold overseas (as the wiring can be quite different from country to country). This harness does make a connection for 12v ignition in the American version of the Chevy Colorado. [ Jeff  Feb 25, 2014 ]  Staff
The ability to retain steering wheel controls with aftermarket receivers will be determined by the receiver you are using and the vehicle you have. For full information on this type of integration (including the parts you will need) please contact an Advisor by phone (1-800-324-9695) or online chat. [ Krissy  Feb 05, 2014 ]  Staff
For details on fit or installation please contact an Advisor by phone or online chat. They will be able to pull up your vehicle and give you the details and what you will need for an installation in your vehicle. [ Jeff  Jan 06, 2014 ]  Staff
Originally I had just the installed 2 way speakers and now I have 1 fosgate p3 10" woofer with jl 300 mono and everything operates the same. [ AARON E  Dec 31, 2013 ]
I installed this on a 2004 Chevy Silverado. The wires on the harness solder into the wires from stereo,as well as about three wires from the door chime. Then just plug into your old wire plug from your car to your new harness you just soldered onto your stereo stereo. They are all color coded and makes it easy, I did not use an additional amp, but I think the amp plugs into the stereo by RCA cables, so it would not make a difference. One more word of advise, wrap the new door chime in bubble wrap before placing in dash to stop any rattling noise while driving. Lots of videos on youtube! Good luck! [ JOHN  Dec 27, 2013 ]
Since it's wired directly to your factory harness, it shouldn't be a problem. [ PHILL  Dec 27, 2013 ]
I do not know the answer to this question [ ROB  Dec 27, 2013 ]
I was installing on an unamplified system, but it did have the wire to integrate the remote amp power control from the aftermarket stereo to the factory harness. I assume it would probably work... [ FRANK  Dec 27, 2013 ]
Articles
 
 
 
 

would like to send you to a different page.

Go there