Features

Marine Amplifier: This Wet Sounds SYN-DX series marine amplifier features a completely sealed die-cast aluminum chassis to keep out water, making them ideal for extreme marine applications. The SYN-DX amplifiers feature chassis that are raised 3/8" above the mounting surface to help keep the amplifier cool, and prevent direct contact with water. The SYN DX-6 is a 6-channel that can drive full-range speakers and subwoofers in many configurations.

Class D Amplification: The SYN DX-6 features state-of-the-art Class D amplification which provides ample power in a small chassis. The amp's power output is as follows:

• 125 watts RMS x 4 + 150 watts RMS x 2 @ 4 Ohms
• 200 watts RMS x 4 + 300 watts RMS x 2 @ 2 Ohms
• 400 watts RMS x 2 + 600 watts RMS x 1 @ 4 Ohms bridged

Control Panel: The top-mounted control panel is protected by a cover to help keep the controls dry, and to prevent unwanted adjustments. The cover screws can be removed with a 2.5 mm Allen wrench. The rotary controls and recessed slide switches require the use of a narrow flat-head screwdriver to make adjustments. This amplifier features independent controls for Channels 1-2, Channels 3-4, and Channels 5-6:

• Input Mode: Two switches are provided to indicate the source of the audio signals for Channels 3-4 and Channels 5-6. The six channels can receive signals from one, two, or three pairs of connected inputs. Channels 3-4 can receive signals from a source connected to the Channel 1-2 or Channel 3-4 inputs. The signal for Channels 5-6 can be obtained from Channels 1-2 or Channels 5-6. If you use only one pair of inputs, there will be no fading capabilities between the front and rear outputs.
• Crossovers: Each pair of channels has a 3-way switch that lets you set the crossover for low-pass, high-pass, or full-range operation. The rotary controls lets you set the low-pass or high-pass frequency between 50 Hz and 250 Hz. The crossovers have a 12dB/octave slope.
• Gain: The Gain controls let you match the amplifier input to the output of source unit. The input sensitivity of the amp ranges from 0.2V (Min) to 6.0V (Max).

Connections: The Wet Sounds SYN DX-6's wiring connections are on one side of the amplifier for a clean installation. The connections are as follows:

• Power/Ground: The power and ground connections feature set-screw terminals that will accept up to 4-gauge wire.
• Remote Turn-on: The Remote Turn-on connection is a set-screw terminal that will accept up to 8-gauge wire.
• Speaker Outputs: The amp has C-clamp terminals for all six channels. The terminals will accept 12-gauge to 16-gauge speaker wire. A small flat-head or Phillips-head screwdriver is needed to tighten/loosen the C-clamp screws.
• Inputs: The amp features three pairs of RCA jacks for connecting the source unit.