About the Q-Forms Kick Panel Enclosures

What's in the box:
- 2 Medium Beige plastic Q-Forms
- Plastic computer housing
- Two 13" pieces of rubber welt trim
- Two 1" Self-tapping screws
- Two 6 x 8-inch pieces of Polyfil
- Installation Instructions
- Q-Forms "C-series" instruction sheet
Other info:
- MFR # QL-K1011C11
- Item # 044C101111
More details on the Q-Forms Kick Panel Enclosures

Product Research
Features
Product Overview: Q-Logic C-Series Q-Form custom kick panels are designed to hold a 2-way component speaker system consisting of a woofer up to 6-1/2" and a tweeter (up to 2" diameter). They are fabricated of durable ABS plastic, color matched to the factory interior colors, and replace the factory kick panels. The positioning and angle of the speakers provide optimum stereo imaging and staging.
No Grilles: Because no grilles are included with the Q-Forms, you must use the grilles supplied with the component system. In some cases, the grille could slightly overlap the mounting surface for the woofer. In this case the cutout can be made so any overlap occurs at the back bottom edge where it will not be visible.
Note: One of the included installation guides states that two Q-grilles are included, but that is not the case.
Compatibility: These Q-Forms are designed to fit select 1978-1988 Buick Regal and Grand National, Chevrolet El Camino and Monte Carlo, GMC Caballero, Oldsmobile Cutlass, and Pontiac Grand Prix models.
Note: Please enter your vehicle information to verify compatibility.
Factory Colors: These kick panels match the factory Medium Beige interior trim.
Installation Notes
Installation Overview: You will need to cut out the mounting holes in the designated areas of the plastic Q-Form. A roll of foam tape is provided for sealing the woofer in the kick panel. The tweeter can be flush or surface mounted. Giving exact mounting depths is not possible, since it will depend to some extent on the space available behind the factory kick panel. (Q-Logic advertises 4" minimum.)
Modifications: Installing this Q-Form requires two modifications to the vehicle. You will need to use two crescent wrenches and bend the parking brake pedal arm so that the pedal pad is relocated approximately 1.5" to the right. If your vehicle is equipped with an engine computer in the passenger side kick panel, you will need to relocate it under the passenger floor board carpet using the plastic housing provided.
Loading...
Loading accessories...
Customer Q&A
4 questions already asked
Loading...
Loading articles...
Works great just had to modified a little bit to work better but looks good painted
David from Iowa