About the Axxess XSVI-2004 Wiring Interface
The Axxess XSVI-2004 amplifier turn-on interface lets you install a high-powered aftermarket receiver into select 1997-2004 Chevrolet Corvette vehicles without bypassing the premium factory system. The interface provides an amplifier turn-on signal and a 12-volt accessory power lead for your new stereo. You'll also be able to adjust the volume level of the amplified woofers in your doors. Warranty: 1 year.
Note: If you haven't already, please enter your vehicle information or call an Advisor at 1-888-955-6000 to find out if this interface is compatible with your vehicle.
Customer reviews for Axxess XSVI-2004 Wiring Interface
Average review:4.5 out of 5 stars
Thanks for submitting your review
More details on the Axxess XSVI-2004 Wiring Interface
Overview: In the 1997-2004 Chevy Corvettes there are not 12-volt accessory wires currently in the factory harness making the installer run an accessory wire to the fuse box or underneath the steering column when installing an aftermarket radio. The Metra Axxess XSVI-2004 Amp Interface is designed to provide a 12-volt, 10-amp switched accessory output along with the rest of the wires needed to install an aftermarket radio.
R.A.P.: The R.A.P. (Retained Accessory Power) function, where power is supplied to the radio after the ignition is shut off until one the doors are opened is retained by the XSVI-2004 Amp Interface module.
Differential Line Converter: The XSVI-2004 will also retain the amplified door woofers through the use of a differential line converter. This helps eliminate turn on/off pops and allows you to adjust the level of the doors woofers. The XSVI-2004 Amp Interface module features four potentiometers (Front left/right and Rear left/right) to increase or decrease the audio level of the door woofers.
Installation: The Metra Axxess XSVI-2004 installs behind the vehicle's factory radio and connects between the factory radio's plug and vehicle harness. The XSVI-2004 Amp Interface module provides plug-in connectors as well as hard-wire connections.
Initialization: Once all the connection are completed, turn the vehicle's ignition key to the "On" position for thirty seconds and then turn the key off.
8 questions already asked