Contact us
Close contact box
Connect ID #
357 094 238 4
Connect ID #
357 094 238 4
Don't wait on hold. We'll call you back when it's your turn to talk with the next available .
Please enter your name  
Please enter your phone number  
Please enter a message  

Calls may be recorded for training and quality control purposes.

We are located in Virginia USA.

Thank you. We will be calling you .
We're sorry. We have encountered a problem.

Jared S's 2004 Chevrolet Cavalier

You can view Jared's previous installation in his Cavalier here

Current Items installed:

  • Pyle Dryver 3600 watt mono block
  • Pyle Dryver 2000 watt 4 channel
  • 2 Kinetik HC800 car audio batteries
  • Pyle Dryver 50 farad hybrid capacitor
  • 2X Power Acoustik FX series subs 12" with kevlar cones. Dual 4ohm
  • 2X Pyle plg69.8, 8 way speakers in rear
  • 4X Volfenhag (ZX-846R) 350 watt speakers, 2 in front and 2 in trunk
  • Custom enclosure made of fiberglass and 3/4 MDF. Built in clear acrylic plates and finished with Neon blue carpet.
  • 100 blue led's and 6 blue neon tubes for lighting
  • 16 ga to door speakers and 12 ga to each subwoofer coil.

Installation Description

The installation started with a month of planning. The design needed to support all of the components and still leave room to put luggage into the trunk if needed. The final design still leaves access to the spare tire. The actual building took 45 days and started with the fiberglass. The fiberglass is on the sides of the trunk to maximize the volume of the enclosures, and is then connected to 3/4 MDF for the flat exterior of the enclosure. The next part was the center - each component has it's own box and is surrounded with blue LED light. The amps are in the front, the capacitor is in the middle, and the batteries are in the back. I also included 2 120mm fans to keep the amps cool in their confined environment. I ran everything together with 0Ga wire for power/ground and used 14 and 16 gauge for the door speakers. The head unit is stock for now but I plan on adding a carputer of my own design.Final cost of all components and materials was under 1000. This is not a show stopper and was not intended for that. This is just a driving car that has a nice trunk for parties.

Q&A Section

Why did you decide to upgrade your A/V system?

To have something to use for music at the parties out in the middle of nowhere.

What's the first thing you show people about your installation?

First I give them a taste of the sound. Then I lift the trunk and show them the goods.

Why did you choose these products?

They had adequate output for the price.

What was the most difficult part of the installation?

Getting everything to fit. On the first try the trunk lid did not close. Overall, the installation required lots of tweaking.

What plans, if any, do you have for future upgrades?

Carputer and replacing the head unit.

fiberglass molded to the inside of the trunk

fiberglass molded to the inside of the trunk

Placement of the windows

Placement of the windows

side view of one of the boxes with lights

side view of one of the boxes with lights

fitting the parts and testing

fitting the parts and testing

Final result

Final result :)

Baby Blue

Baby Blue

Compare the sound